Here is the initial patterns, tomorrow I will finish dialing this in and button up this axle.
Spartan Lockers are in my experience are the worst. I bought 2 of these during my one ton build. Having had Aussie Lockers and Lock-Right lockers in the past with great success, and being budget build it seemed like a good idea.
The first one wore out after a year of wheeling. It was installed in my front axle and oddest thing is that with the lock out hubs the carrier never spun much. I ended up removing it last winter in favor for a grizzly. Upon inspection it had a lot of chipped teeth on the side gears and cams.
Now 2 years after the original install, I broke the ring gear, I pulled the Spartan locker out of the rear to find this:
The last trip of the year to Field and Forest has traditionally been the major breaking point of the year for the jeep.
Last year I sheared the teeth off in my steering box, forcing me to upgrade to full hydraulic steering. Breaking things are almost a blessing in disguise in my experience. For example then I broke my steering box last year, it allowed me to move onto the next step of the build, which was upgrading the steering and lowering the jeep 4 more inches since the steering gear box would not be in the way any more.
Lets hope that this prove true with this break…
Well I am starting to collect the parts required to build my new Dana 300 transfer case. So far I have collected the D300, a rebuild kit and a set of LOMAX 4:1 gears from JB Conversions. Saying these things are beefy is an understatement. Once I get some side by side pictures you will understand, but meanwhile you can look are the few pictures I have. I am only waiting on my input shaft and adapter from NOVAK, which should be here tomorrow then I can start the build!
So since the rebuild the 231 been “popping” out of low range. Its odd because at first I thought it could’ve been the shifter but after disconnecting the shifter and shifting it by hand, it made no differences. I believe that its a failed snap ring because the rebuild kit didn’t come with new ones.
This motivated me to start the next big thing. I picked up a Dana 300 to replace the 231. It is a much stronger unit due to being 100% gear driven (no chain) and its about 4″ shorter and the 231, this will allow for better driveline angles. The other reasons why I want to make the switch is that the 300 is simpler (having only 6 gears) and that I will gain the ability for front digs.