Adjusted The Rear Upper Control Arms

Well I Just Adjusted The Rear Upper Control Arms To Remove The Drive Line Vibes…

Tools Needed

  • 420 Channel Locks
  • Ratchet
  • 15mm Socket

Before

First I Lossed The Retaining Nut With The Channel Locks on both Rear Upper Control Arms

Then I Used The Ratchet and 15mm Socket To Remove The Upper Control Arm Bolt From The Frame Pocket

While Both Arms Are Hanging Down Turn Them Both Counter Clockwise To Extend Them

Remember to do both side equally, if you have any hope of retaining your current alignment

After you extend the control arms to the desired lenght, you can reinstall the control arm bolts in the control arm pocket…

you’ll have to push up on the pinion to roll the pinion up so you can line up the arms to the bolt holes in the pocket

i highly recommend to use a floor jack for that… but i just used brute strength to roll the pinion up.

once those bolts are tight, dont forget to retighten the Retaining Nut With The Channel Locks on both Rear Upper Control Arms

[u][b]After:[/b][/u]

And Now I Have No More Drive Line Vibes!

Leave a Reply